As you will see, all work completed on the drive line was "out of car" & laid on a custom fabricated cart.  Then the car was raised on our lift.  Why out of car?  Dirt control, and the ease of not fighting to do the job "under the cowl".  It looked like a a lot of work but, it was a pleasure doing it this way.

Completed work is as follows:
-CNC Ported Cylinder Heads install
-Performance Camshaft
-ZO6 Flywheel, Pressure Plate, and Clutch
-Front Transmission Seal (it leaked)
-ZO6 Intake Manifold
-Dyno Tuned

The customer supplied most of the parts.  The labor on this job was approximately $2200.00, and all the work was completed in only 3 days !!!

The work gained approximately 70 Rear Wheel Horsepower.  That's close to 100 at the engine.  The previous work produced 30 Rear Wheel Horsepower, and so we were pleased with the total gained 100 Rear Wheel Horsepower.  All this with no power adders, and on pump gas ! WOW! 

Labor only prices as follows:

-Cam install only $550.00 Engine in car
-Heads install only $1075.00 Engine out of car
-Heads & Cam install only $1475.00  Engine out of car
-Heads, Cam & Clutch install $1675.00  Engine out of car.

Add on's and any unforeseen problems are additional.  Dyno tuning is extra.

CLICK HERE FOR PHOTOS OF THIS JOB

CLICK HERE FOR DYNOJET Performa Evaluation Program Charts